Cisco WS-SUP720-3B - Supervisor Engine 720

98 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Contents

vi

Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide

OL-10100-11

SC Connectors B-16

MT-RJ Connectors B-17

LC Connectors B-17

Cleaning the Fiber-Optic Connectors B-18

LX/LH GBIC and MMF Cable Considerations B-19

Patch Cord B-19

Patch Cord Configuration Example B-19

Patch Cord Installation B-20

I

NDEX

Table of Contents

Default Chapter3
- Default Chapter3
- Document History8
Document Organization8
Document Conventions9
- Warning Definition9
Related Documentation10
Obtaining Documentation, Obtaining Support, and Security Guidelines10
Chapter 1 Cisco 7600 Product Overview11
- Cisco 7600 Series Routers11
  - Supported Hardware12
  - Features13
Table13
- Cisco 7600 Series Routers13
- Port Addresses16
  - Physical Interface Addresses16
  - MAC Addresses17
- Supervisor Engine 2T18
Chapter 2 Route Switch Processors and Supervisor Engines19
- C H a P T E R 2 Route Switch Processors and Supervisor Engines20
- Overview20
- Route Switch Processor 72027
- RSP720 with 10GE Uplink Ports28
- Supervisor Engine 2T33
  - Primary Supervisor Engine 2T Components35
- Supervisor Engine 720 and Supervisor Engine 3239
  - Front-Panel Controls (RSP720, RSP720-10GE, Sup720, Sup32)39
  - Front-Panel Leds (RSP720, RSP720-10GE, Sup720, Sup32)40
- Supervisor Engine 241
CHAPTER 3 Installing and Configuring Route Switch Processors and Supervisor Engines45
- Preparing for Installation or Removal45
Preparing for Installation or Removal46
Determining Module Location47
- Tools Required for Module Installation47
Installing a Supervisor Engine or Route Switch Processor48
Removing a Supervisor Engine or Route Switch Processor51
Hot Swapping (OIR) Modules52
- Removing and Replacing Memory52
Connecting to the Console Port53
- Connecting a Terminal53
- Connecting a Modem54
Connecting to the Uplink Ports54
Using Flash Memory Cards56
- Installing a Flash Memory Card57
- Removing a Flash Memory Card58
Power Management and Environmental Monitoring58
Determining Software Feature Support58
Upgrading Dimms on RSP72058
Configuring a Supervisor Engine or Route Switch Processor61
Chapter 4 Troubleshooting Route Switch Processors and Supervisor Engines63
- Getting Started63
- AC and DC Power Supply Information63
- Chassis and Supervisor Slot Installation64
Appendix73
Technical Specifications73
- Module Specifications73
- Regulatory Standards Compliance73
- Appendix A Technical Specification74
  - Regulatory Standards Compliance74
Appendix75
Cable and Connector Specifications75
- A P P E N D I X B Cable and Connector Specifications76
- Supported Dense Wave Division Multiplexing (DWDM) Wavelength Optics76
- Supported Coarse Wave Division Multiplexing (CWDM) Wavelength Optics78
- Limiting Connection Distances79
  - Uplink Port Transceiver Modules79
    - 1GE Uplink Ports and Cabling Specifications80
Uplink Port Transceiver Modules80
- 10GE Uplink Ports and Cabling Specifications82
- GBIC Module Cabling Specifications83
- Console Port Cabling Specifications and Pinouts84
- RJ-45 Connector88
- Fiber-Optic Connectors90
LX/LH GBIC and MMF Cable Considerations93
- Patch Cord93
  - Patch Cord Configuration Example93
  - Patch Cord Installation94

Related product manuals

Preview: Cisco WS-C2960-24LC-S

Cisco WS-C2960-24LC-S

Preview: Cisco WS-C4507R

Cisco WS-C4507R

Preview: Cisco WRVS4400N

Cisco WRVS4400N

Cisco Linksys WET11

Preview: Cisco Linksys WET610N

Cisco Linksys WET610N

Preview: Cisco Linksys WRT54GS

Cisco Linksys WRT54GS

Preview: Cisco Linksys WRT610N

Cisco Linksys WRT610N

Preview: Cisco Linksys WRT300N

Cisco Linksys WRT300N

Preview: Cisco Linksys WRT600N

Cisco Linksys WRT600N

Preview: RV042 - Small Business Dual WAN VPN Router

RV042 - Small Business Dual WAN VPN Router