3-15
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
OL-10100-11
Chapter 3 Installing and Configuring Route Switch Processors and Supervisor Engines
Upgrading DIMMs on RSP720
router#show module 1
Mod Ports Card Type Model
Serial No.
--- ----- ----------------------------------------------------
------------------------------ ------------------------
1 2 Route Switch Processor 720 (Active) RSP720-3CXL-GE SAL15077HPS
Mod MAC addresses Hw Fw Sw
Status
--- ------------------------------------------------ ------- --------------
-------------------------- -------
1 c89c.1dfa.fb34 to c89c.1dfa.fb37 5.12 12.2(33r)SRE 12.2(33)SRD5 Ok
Mod Sub-Module Model Serial
Hw Status
---- -------------------------------------------- -------------------------
----------------------- ------- -------
1 Policy Feature Card 3 7600-PFC3CXL SAL150673QR 1.1 Ok
1 C7600 MSFC4 Daughterboard 7600-MSFC4 SAL1542T06C 4.0 Ok ? ? ? <- <-
Mod Online Diag Status
---- -------------------
1 Pass
Order MINI- DIMM if your MEM PIDs are:
• MEM-RSP720-2G
• MEM-RSP720-4G
• MEM-RSP720-SP2G
Order SO-DIMM if your MEM PIDs are:
• MEM-A-RSP720-2G
• MEM-A-RSP720-4G
• MEM-A-RSP720-SP2G
7600 chassis supports RSP720-GE and RSP720-10GE. Figure 3-6 shows the location of the DIMMs.
DIMMs are located on the CPU daughter card and you can see it on top of the Figure 3-6. SP has one
DIMM slot and RP processor has two DIMM slots. Slot 1 and 2 are for the RP processor. Slot 3 is for
the SP processor.
To Next Page
Loading...
