23
8.
Setting the Time
The analog time cannot be corrected by operating the crown. It can only be
corrected with the digital display.
1. Turn the crown and set the mode hand to the time [TME] mode.
2. Press either button (A) or button (B) to select the city to be corrected.
3. When the crown is pulled out to the second click (time setting position), the
watch enters the time correction state.
4. When button (A) is pressed, the location to be corrected changes each time it
is pressed. Select the location to be corrected. (The location that is flashing
is the location that can be corrected.)
• When button (B) is pressed in the [SMT] daylight savings time correction
state, daylight savings time can be set (ON) or canceled (OF).
• "Seconds" return to zero when button (B) is pressed in the "seconds"
correction state.
• When the crown is turned forward (clockwise) in the "hour" or "minute"
correction states, correction is made in the positive direction. Turning the
crown continuously allows "hours" or "minutes" to be corrected continuously.
Although correction can be made in the negative direction when the crown is
turned backward (counter-clockwise), always make sure to turn the crown
forward to ensure that the time is set correctly.
22
• Switching "12H/24H time" is performed by pressing button (B).
5. After corrections have been completed, return the crown to the normal
position.
<Procedure for Correcting the Analog Time>
1. Simultaneously press buttons (A) and (B) in the [TME] mode.
• The display switches to the digital display (analog
→
digital).
2. Correct the time with the digital display (refer to steps 2 through 5 of section 8
on Setting the Time).
3. Again press buttons (A) and (B) simultaneously.
• The display switches back to the analog display (digital
→
analog).
To Next Page
Loading...
