<All-Reset Procedure>
1. Turn the crown to set the mode hand to the chronograph [CHR] mode.
2. Pull out the crown to the second click (0-position correction mode).
• The second hand, minute hand, hour hand, 24 hour hand, UTC hour hand
and UTC minute hand rapidly advance to the 0 position stored in memory.
3. Press buttons (A) and (B) simultaneously and then release.
• All segments of the digital display are shown when either of the buttons is
released.
4. This fully lit display is canceled when the crown is returned to the normal
position.
• After canceling, a confirmation tone is sounded after which each of the
hands perform a demonstration movement in the order of the second hand,
minute hand , UTC minute hand, UTC hour hand and 24 hour hand to
indicate that the all-reset procedure is finished.
• After the demonstration movement, pull the crown out to the second click to
switch the watch to the watch base position setting state.
Always make sure to set the 0 position (base position) for the hour hand,
minute hand, second hand, 24-hour hand and UTC hour and minute hands
while referring to "5. Checking 0-Position of Each Hand <0-Position
Correction>".
Note:
• After setting the 0 position (base position) for each hand, correctly reset the
time, calendar and other modes before using the watch.
44 45
(B)
(A)
Normal position
2nd position
To Next Page
Loading...
