— 45 —
(15) ×4 Enlarged Letter Assignment (FS + “W” + 1) Command
FS (1CH) + “W” (57H) + 1 (01H) code input, ×4 enlarged letters are assigned.
Data following this code are printed vertically and laterally twice enlarged.
(16) ×4 Enlargement Cancel (FS + “W” + 0) Command
With FS (1CH) + “W” (57H) + 0 (00H) code being input, ×4 enlargement
assignment is cancelled.
Note 1: Although standard and laterally enlarged letters can coexist in one
line, automatic (buffer-full) printing takes place on reaching to 24th
(40th) column counted in standard characters.
Note 2: With ×4 enlargement and double-width having been assigned, ×4
enlargement has priority.
Application Example)
[Receiving Data]
1C W 1 123456789 CR
1C W 0 ABC 1C W 1 123 CR
1C W 0 A 1C W 1 12345678901B
<Printing Results>
123456789
ABC123
A1234567891B The last letter, although in ×4 assignment, is printed
in standard letter since it being in the 24th column.
(For 40 column mechanism, this applies to the 40th
column.)
(17) Set Line Spacing (ESC + “A” + n) Command
Sets a line space of “n2” dot line by the entry of ESC (1BH) + “A” (41H) + n
code. Initial setting is 2-dot line space.
Here, n is an even number in the range of 0 ≤ n ≤ 255.
Note: When an odd number is set to n, a line space of n−1 dots is specified.
When n=0 or 1 is specified, continuous printing is permitted.
To Next Page
Loading...
