— 46 —
NOTE
When the set value is outside the specified range, writing to memory is not carried out.
n1 Function n2 Content of Setting
0
Select international character set
0~8 See International Character Code Table.
1 Select code page. 0~11, 253, See Character Code Table Select
254, 255 Command.
2 Select 910/3110 emulation 0 910 Emulation
1 3110 Emulation
3 ACK timing *1 0 Before
1 Center
2 After
4 Enable/Disable paper-near-end 0 Enable (Valid)
1 Disable (Invalid)
5 Online state at power on 0 Select (Online)
1 Deselect (Offline)
6 BUSY timing *1 0 Standard
1 CBM-910
7 Buffer Size (Serial I/F) 0 2k bytes
1 72 bytes
(18) Change Memory Switch (ESC + “)” + 55 (H) + n1 + n2 + AA(H))
Entering this code allows the contents of the memory switch shown in the
table below to be changed.
When the printer receives this code, it enters the BUSY mode.
After writing to memory switch, reset is carried out and the receive buffer/
print buffer is cleared and the initial value is restored and then the contents
of the memory switch is reloaded.
*1: Setting is permitted only for parallel interface.
To Next Page
Loading...
Need help?
General
