Chapter 4 Media (Paper) and Ribbon
− 20 −
(3) Unlock the media guide lock screw and move both side media guides to their maximum
outward position.
4. Install the roll media as follows:
(1) Place the media holder shaft onto the round notches on the media guides and media holder
shaft supporting plates.
(2) Move both media guides by using both hands so that they come into contact with the edges
of the roll so that no clearance is left between media guide and media.
(3) Lock the media guides with the media guide lock screw turned clockwise.
Printhead assembly
Transparent sensor
guide
Printhead release lever
Transparent sensor
guide release lever
Media guide (on both
sides)
Media guide lock screw
Media guide lock
screw
Round notch on media
holder shaft supporting
plate (on both sides)
Media holder shaft
Media guide (on
both sides)
To Next Page
Loading...
