Citizen CZ-01

17
7
Remove the old paper roll from the paper holder, and then set the new paper roll
ensuring there are no gaps.
If the paper protrudes, remove the roll from the paper holder and set the edge face of
paper at.
Set the roll so that
there are no gaps.
Set the paper so that
it does not protrude
from the roll.
Caution
• When setting the media, make sure to use the plastic bag or sheet covering the
media. Never put it directly on the table, oor or work spaces.
Printer Installation
Paper holder
6
Remove the paper holder from the printer.
Caution
• When removing the paper holders to change the paper roll etc., make sure to place
them on the clean surface. Never place them directly on the table or work spaces.
If dust or dirt adheres to the media when setting the paper holder inside the printer
unit, it may adversely a󰀨ect the print quality.