10
Caution for installation
• Before using the product, read “For Safe Operation” carefully and observe the
instructions therein.
• Do not use or store the product near a fire, humid places, in direct sunlight, near an
air conditioner or heater, or any other location with unusually high or low temperature,
strong humidity, or excessive dust.
• Do not place the product where chemical reactions occur, such as in a laboratory.
• Do not install the product where there is salinity or corrosive gas in the air.
• The product must be installed on a rm, level surface where there is ample ventilation.
• Do not put anything on top of the product.
• Do not use the product near a radio or television, and do not use the same wall outlet
for the product and a radio or television. Otherwise radio or television reception may be
adversely aected.
• Do not use a power voltage or a frequency other than those specied.
• Do not put anything on the power cord or step on it.
• Do not drag or carry the product by the power cord or the USB cable.
• Avoid plugging the power cord into an outlet with many other cables connected.
• Do not bundle the power cord.
• Always grip the plug housing, not the cord, to plug or unplug the power cord.
• Always unplug the power cord before connecting or disconnecting the USB cable.
• Avoid using a long USB cable or connecting it to any noise-producing device. If it is
unavoidable, use a shielded cable or twisted pair for each signal.
• Use a shielded USB cable compatible with the USB 2.0 specications.
• Place the product near the outlet where the power cord can be unplugged easily to shut
the power o.
• Use an AC outlet that accepts a three-pronged plug. Otherwise, there may be a danger
of electric shock.
• For regions where the power cord is supplied with the product, use this included power
cord set for the product. Do not use the power cord set with other devices.
• When using a portable power source, be sure to read the user guide of the portable
power source, and be sure to ground the portable power source. Otherwise, there may
be a danger of electric shock.
• This product is not intended for use in the immediate/direct visual field of the display
work place. To avoid disturbing reections on the display work place, this product shall
not be placed in the immediate/direct eld of vision.
• Use as a network printer is not anticipated. Any use in conjunction with a network will be
the customer’s sole responsibility.
• This device is not appropriate to be used where a child may be present. Install, store, or
use the device where it cannot be reached by a child.
To Next Page
Loading...
Need help?
General
