10
2. Preparation
2-1. Connecting LAN cable
Connect a LAN cable to the RJ45 connector of
this interface board. (Diagram on right shows a
typical example)
2-2. Connecting a Peripheral Device
The following restrictions apply to peripheral devices. Please use them properly.
• The connection of unsupported peripherals to the USB port is prohibited. (please inquire about
which devices are supported).
• Connecting a tablet or other device to USB ports for supplying power is also prohibited.
• Do not insert or remove peripheral devices from the USB port while the printer power is on.
• Connection through a USB hub is prohibited.
• In the case of the IFx-EFX2 which has two USB ports, connecting to both the left and right ports is
possible, but connecting two of the same type of device (two displays, two scanners, etc.) is
prohibited.
To Next Page
Loading...