3. Network Settings and Operation
17
3-4. Returning the Interface Board Configuration to Factory Default Settings
1) Press and hold the panel button to switch to setting mode.
2) After the interface board has switched to setting mode, press and holds the panel button again
within three seconds. The following message is printed, and the interface board returns to factory
default settings.
I/F Board
Information
--!Caution!--
Print Server will
automatically restart.
When the operation completes, this interface board restarts automatically.
When automatically obtaining the IP address from the DHCP server is set, an IP address that
differs from the previous one may be assigned.
To Next Page
Loading...