4. Web Manager
29
4-4-3. CONFIG>>Maintenance Tab
・ Save & Restart button
Save changes, and restart the Interface board.
・ Restart button
Restart the Interface board without saving changes.
・ Factory Default button
Return the Interface board to the factory default settings.
・ Firmware Upgrade button
Upgrade the firmware of the Interface board.
Firmware upgrade
1) Click “Browse” and select the firmware file.
2) Click “Write”.
Warning
After the firmware upgrade starts, do not disconnect power or transmission to the printer until the
upgrade is complete.
When updating the firmware, it is necessary to obtain the correct firmware data from us.
If the firmware is not updated correctly, this interface board may not boot.
To Next Page
Loading...