3. Network Settings and Operation
15
3-2. Panel Button
The panel button on the operation panel is used to operate the Interface board. It allows you to print
the setting information of this interface board and restore the initial state. (Diagram is of IF1-EFX1
and IF1-EFX2)
Starting the Interface Board
Turn on the printer. The Interface board starts working approximately 20 seconds after the printer
turns on.
Printing the Interface Board Configuration
Press the panel button. See 3-3, Printing the Interface Board Configuration (page 16) for details.
Switching to Setting Mode
Press and hold the panel button. The buzzer
*
will sound once, signaling a switch to setting mode.
・Setting mode enables the reading of the factory default settings. See 3-4, Returning the Interface
Board Configuration to Factory Default Settings (page 17) for details
・If there is no activity for three seconds in the setting mode, the buzzer
*
will sound once, signaling a
return to normal mode.
* If the printer to which this interface board is connected is set to not buzz, the buzzer will not
sound.
System log printing
If printing etc. does not work as expected, you may be able to check the situation by checking
the system log of this board. The system log can be printed using the panel buttons.
Please refer to Chapter 5 "Useful Functions for Request Print" in the "Programmer's Manual for
"Request Print" for a description of system log printing.
When the operation is complete, the interface board will restart automatically.
When automatically obtaining the IP address from the DHCP server is set, an IP address that
differs from the previous one may be assigned.
Warning
Panel button
Panel button
To Next Page
Loading...