4. Web Manager
27
4-4-1. CONFIG>>General Tab
LAN board Information
・ LAN board name (factory default: Net Printer)
Set the ID of the Interface board.
TCP/IP
・ Obtain an IP Address Automatically (factory default)
Automatically obtain the IP address from the DHCP server.
・ Use the following IP Address
Enter IP addresses in the IP Address, Subnet Mask, and Default Gateway fields.
UPnP Setting
・ UPnP (factory default: Enable)
Set the UPnP setting.
Print Settings
Configure the printing functions of the printer.
・ Raw Port Number (factory default: 9100)
Set the TCP port number for RAW protocol printing.
・ Timeout for print data
Set the timeout duration for the connection to the host.
・ Action at Timeout
Select the action for other connections when a timeout occurs with the host. There are two
selections: Close all connections and Move to next connection.
To Next Page
Loading...