CITROEN 2015 Berlingo Multispace

184
Berlingo-2-VP_en_Chap08_Aide-rapide_ed02-2015
Changing a bulb
Berlingo-2-VP_en_Chap08_Aide-rapide_ed02-2015
Rear lamps
This procedure requires the use of
the spanner supplied with the tools for
changingawheel.
Whenretting,takecareto
reposition the tabs and the wiring
correctly to avoid trapping the
wiring.
After changing the rear direction
indicatorbulb,thereinitialisationtimeis
above2minutes.
- Move aside the 4 tabs then extract
thebulbholder.
- Removethefaultybulbby
pressing it lightly while turning it
anticlockwise.
- Changethebulb.
Whenremovingthelampunit:
- withtailgate,pullthelampunit
towards the centre of the vehicle,
- withhingeddoors,pullthelamp
unittowardsyou.
Formoreinformationonbulbs,referto
the"Typesofbulb".
1. Brake lamps / sidelamps
Type B,P21/5W-21/5W
2. Direction indicators
Type B,PY21W-21W(amber)
3. Reversing lamps
Type B, P21W - 21W
4. Foglamps
Type B, P21W - 21W
High pressure jet washing
When using this type of washing
on stubborn dirt, do not persist on
theheadlamps,theotherlamps
andtheiredgestoavoiddamaging
theircoatingandseals.
Chapter9,"Changingawheel"
section.
- Identify the failed bulb, then open
thereardoorsto180°.
Chapter3,"Access"section.
- Removethetwoxingboltsusing
thespannerprovided.
- Pullthelampunitfromtheoutside.
- Holdingthelamp,disconnectthe
electricalconnector.