CITROEN 2015 Berlingo Multispace

66
Steering mounted controls
Berlingo-2-VP_en_Chap04_Ergonomie_ed02-2015
Changing the
programmed speed
Switching the system off
Operating fault
Cancelling the programmed
speed setting
Whenthevehiclebecomesstationary,
after switching off the ignition, the
systemnolongermemorisesaspeed.
Therearetwomethodsofmemorising
a speed higherthanthepreviousone:
- Place the dial in position 0 or switch
off the ignition to switch everything
off.
Good practice
Without using the accelerator
- Press the SET +button.
Abriefpressincreasesthespeedby1mph(km/h).
Amaintainedpressincreasesthespeedin
stepsof5mph(km/h).
Using the accelerator
- Exceedthememorisedspeeduntil
the speed required is reached,
- Press the SET + or SET -button.
Tomemoriseaspeedlower than the
previousone:
- Press the SET -button.
A brief press decreases the speed by
1mph(km/h).
Amaintainedpressdecreasesthe
speedinstepsof5mph(km/h).
Theprogrammedspeedsettingis
clearedandreplacedbythreedashes.
Contact a CITROËN dealer or a
qualiedworkshoptohavethesystem
checked.
Whenchangingtheprogrammed
speedsettingbymeansofa
maintainedpress,payattentionas
the speed can increase or decrease
rapidly.
Do not use the cruise control on
slipperyroadsorinheavytrafc.
In the event of a steep slope, the cruise
controlcannotpreventthevehiclefrom
exceedingtheprogrammedspeed
setting.
In any event, the cruise control cannot
replace the need to observe the speed
limitsandtheneedforvigilanceonthe
partofthedriver.
Itisadvisabletokeepyourfeetnear
thepedals.
Toavoidanyjammingunderthe
pedals:
- ensurethatthematanditsxings
ontheoorarepositionedcorrectly,
- neverplaceonematontopof
another.