2
OPERATION No MA. 03 : I~grhdicwts
prdcomis&.
II. CLEANSING PRODUCTS
-
USAGE PRODUCT
R insing LHM hydraulic
Pi
ping
D egreasing of mechanical
a:
ssemblies, when cold
oint face cleanser
‘leaning of carburettors
CHARACTERISTICS
I
MANUFACTURERS.
I
TOTAL
Hydro-rincage
MAGNET 6
OIL AND GREASE
REMOVER
PROTOLAN 3 D
RAVITOL X
MAGSTRIP
SUPER-CLEAN
Carburettor cleaner
P.D.R.
Carbuclin
For a thorough rinse, leave the
product in the circuit for 1000 km
(600m)
TOTAL
C.F.R.
Insoluble, in water, dries rapidly
has high insulating qualities
MAGNUS
Let the product act
(undiluted in solvent ) then
rinse with water
MULLERANDCO
Is used undiluted and must be
rinsed with water
Gelatineous liquid for removing
liquid gaskets and non-metal
gaskets
Ets N BREGER
Ets RAVICOLOR
MAGNUS
Dry cleanser to be used before
application of Loctite products
COMET
Department D.A.V.A.
/
III. SEALING PASTES.
PRODUCT
PROTO-JOINT
CURTYLON
LOWAC
FRENETANCH
FRENEBLOC
FORMAJOINT
SILICOMET
noir
(blark )
CHARACTERISTICS
Resist mechanical stress, and
oil-derived products
MANUFACTURERS USAGE
JEAN - BRASSART
CEFILAC
Department Joint Curty
Clean with alcohol
-
Resists hydrocarbons
SEBIS
Locks and seals any assembly
which is screwed on, but must
remain removable
Sealing of joint faces,
screws, studs and nuts
Locks and seals studs, screws
and nuts with maximum
effectiveness
COMET
Department D.A.V.A.
NOTE : These five
products are available as
a kit, with in addition
SCELBLOC (to be used
when securing bearings,
bushes etc.. ) and SUPER-
CLEAN (cleansing pro-
duct )
Seals joint faces and unions
Seals joint faces, as replacement
of ordinary gaskets
Sealing of door and wind-
screen sealing rubbers
To Next Page
Loading...
