5. Cylinder head :
Aluminium alloy, with hemispherical combustion chambers.
- Original height : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ........................ 90 mm
- Overall flatness to within : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...... 0.10 mm
- Flatness between
fixing holes to within : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.025 mm
a)
Head gasket :
Round clinching
(diameter = 92.5 mm ), the identification mark (( CEFILAC 1) or (( COOPERS )) towards the
cylinder head ( 1985 cc ).
Oval clinching;
the identification mark (( CEFILAC 1) towards the cylinder head (2175 cc ).
Round clinching
(diameter = 96.5 mm ), the identification mark (( CEFILAC )) towards the cylinder head (2350 cc).
TIGHTFNING SEQUENCE
Tiqhtening torques f cold)
Initial tightening . . . . . . . . . . 3 da Nm
( 21 3/‘4 ft.Ib)
Final tightening . . . . . . . . . . . . . 6 to 6.5 da Nm
(43 l/2 to 47ft.Ib)
b) Valve seats :
The valve seats are fitted by temperature
shrinking.
VALVE SEAT WIDTH
INLET
I I I I I I T
17 13 9 5
1 4
8 12 16
EXHAUST
To Next Page
Loading...
