3. CC-Link Communication Function
[SMF-2008-A]
– 3-15 –
3.6. Monitoring the CC-Link Communication State
The communication state can be monitored using AX Tools Ver 2.10 or later.
i) I/O view
Select “Monitor” - “I/O signal state indication” from the menu of the AX Tools to display the
screen for “I/O indication”.
Fig. 3.15. AX Tools monitor menu
ii) Check of I/O
The I/O state by CC-Link communication can be monitored.
“*” shows negative logic, thus, the I/O indication will indicate ON when it is open.
Fig. 3.16. Screen example of I/O indication
iii) CC-Link monitor
Communication error information can be checked by selecting “CC-Link” at the lower part of
“I/O indication”.
Fig. 3.17. Screen example of CC-Link monitor
To Next Page
Loading...