7
EtherNet/IP Connection Procedure
7.2.2. Parameter Settings
Set the IP address of the ABSODEX Driver.
The IP Address is set with AXTools.
Precautions for Correct Use
Refer to 5.5.4. Main Power Supply Sequence of the INSTRUCTION MANUAL ABSODEX AX
SERIES TS TYPE TH TYPE XS TYPE (SMF-2006-A) for information on the turn-on
sequence of the main and control power supplies to the ABSODEX Driver.
Turn ON the main and control
power supplies to ABSODEX
Driver.
Start AXTools.
displayed. Select Online.
Select the communication port
number to be used from the
pull-down list of Communication
port selection.
Click OK.
*If there is more than one serial
port on Personal computer,
display Windows Device
Manager and select the same
port number as the
communications port
(displayed under Ports (COM
&LPT)) where ABSODEX
Driver is connected (example:
COM1).
To Next Page
Loading...