CKD AX9000TS-U6 - Page 25

7
．
EtherNet/IP Connection Procedure
22
7
The New Project is displayed.
The following panes are displayed
in the window.
Left: Multiview Explorer
Top right: Toolbox
Bottom right: Controller Status Pane
Top middle: Edit Pane
The following tabs are displayed
in the bottom middle of the
window.
Output Tab Page
Build Tab Page
8
Double-click Built-in EtherNet/IP
Port Settings under
Configurations and Setup –
Controller Setup in the Multiview
Explorer.
9
The Built-in EtherNet/IP Port
Settings Tab Page is displayed in
the Edit Pane.
Check that the check box of Use
Port 2 is selected.
Enter the following IP address in
the IP Address - Port 2.
IP address: 192.168.1.1
Subnet mask: 255.255.255.0
Controller
Status
Pane
Toolbox
Edit Pane
Multiview
Explorer
Output Tab
Page
Build Tab
Page