CKD GPS3 Series - ２．Installation; Installation Environment; Installation

２
．
INSTALLATION
２．１ Installationenvironment
a）Avoidinstallingthisproductwhereitissubjecttoultravioletrays.
b）Preventinstallationwheretheproductisexposedtoadirectsunlight.
c）Avoidinstallationatplaceswherethereisexcessivevibrationorimpact.
d）Largedrainage
Installtheairdryeranddrainseparatorbeforetheairfilter.
Ifthereisalargedrainagefromthecompressor.Hotandhighlyhumidaircould
shortenthedevicelifeorresultincorrosion.
e）Forcompressorcircuitofwaterlubricationmethod
Takemeasurestopreventchlorine-basedsubstancesfromenteringthe
compressedair.
(1)Avoidusingthisproductunderthefollowingconditions.
・Whereambienttemperatureandproducttemperaturemayfalloutsidetherangeof0to50℃.
・Theairmaybefrozen.
・Thehumidityishighandthetemperaturechangeslargely,causingdewcondensation.
・Seabreezeorseawaterissplashedontotheproduct.
・Avoidusingtheproductinanatmospherecontainingcorrosivegas.
・Avoidusingtheproductinanatmospherewhereozoneisproduced.
２．２ Installation
a)Securingmaintenancespace
Pleasesecureenoughspaceformaintenanceandinspection.
b）Observethefollowingitemswheninstalling:
・Installthisproductsothedetectionportfacesdownward.
・Installthisproductatapositionhigherthantheseatingsurfacetopreventcoolant
fromentering.
・Provideenoughspaceforadjustment,monitoring,andmaintenance.
・Donotstrikeorbumpthisproduct.
・Whenhousingthisproductinabox,provideanexhaustportsoatmospheric
pressureismaintainedinthebox.
・Whenweldingnearthisproduct,coverittopreventspatterfromcomingincontact.
・Wheninstallingthisproductonadevice,checkthatnoloadisappliedtothedevice.
CAUTION
CAUTION
INSTALLATION
２
−5− [SM-P00143-A]