17
CEBIS Calibration
Daily zeroing
This should be carried out with the
machine running with threshing
engaged at maximum no load speed.
The following items should be zeroed
on a daily basis.
1.Set ‘Zero returns’
2.Set ‘Zero yield’
The concave end stops are calibrated
automatically, once every 24hour’s.
When threshing is engaged, the
concave will move from 7 – 50mm
and back to learn its end stops
Seasonal calibration
At the beginning of season before the
combine is used it is advised that the
following items are learnt:
1. Learn cutting height limits, knife (1)
and reel (2) ‘end stops’ in the
Cutterbar section of CEBIS.
2. With threshing and cutterbar
engaged and the machine running at
full throttle, learn the ‘Max no-load
speed’(3).
To allow the machine to display accurate information certain parameters need to be
‘learnt’ either on a daily or seasonal basis.
1
2
1
2
3
To Next Page
Loading...
Need help?
General
