20
Knife
Check that the knife is in good condition in order for it to work effectively. This involves
replacing damaged or broken sections, removing vertical movement by adjusting the
keeps, and making sure that the fingers are not rounded or bent. Regular
checks/adjustments will aid cleaner cutting and reduced stress on the knife drive
system.
Table Auger
The table auger is important for the
transportation of material to the
front elevator.
The timing of the retractable fingers
can be adjusted for different crops by
opening up the guard on the RHS of
the V770 & V930 and adjusting the
lever with a spanner. Use the top
holes for short crops and the lower
holes for tall crops. The 3
rd
hole from
bottom is the standard setting.
Crop Wrapping
If an issue occurs with crop wrapping around the table auger in difficult conditions
there are a number of procedures that can be carried out; try one thing at a time.
Cutterbar
Adjustments
1. Adjust the stripper plates behind
the auger; this is made easier on
this machine by being able to
adjust it from the back of the
header rather than behind the
auger.
2. There is a second scraper under
the auger that can be accessed
over the top of the auger.
To Next Page
Loading...
Need help?
General
