Basic Operations
Setting EQ effects
to
ON/OFF
*
The
factory default setting
is
"ON".
1.
Press and hold the [EQ] button for 1 second
or longer to turn off the EQ effect.
"~"
goes off
in
the display.
2.
Press and hold the [EQ] button for 1 second
or longer to turn on the EO effect.
"~"
lights
in
the display.
Switching the spectrum analyzer
display patterns
You
can select one out of 9 patterns or set it to
off.
*
The
factory default setting
is
"SND BEAT".
1.
Each time you press the
[SPE/ANAj
button,
the
spectrum
analyzer
display
pattern
changes in the following order:
SND BEAT
~
SND WAVE
~
SND RISE
~
SND SNOW
~
CROSS
~
EXPAND
~
HO-
RIZON
~
SHADOW
~
S/ASCAN
~
S/A
OFF
~
SND
BEAT.
..
Note:
The spectrum analyzer display is unavailable dur-
ing these operations below;
o Seek tuning
and
auto store
in
radio mode.
• Pause.
• When "NO DISC",
"NO
CASS"
or
an error
mes~
sage appears
in
the display
•
When
fast-forwarding, fast-backwarding
or
paus-
ing the tape in tape mode.
10
ADB340MP/ADB341MP
Radio Operations
FM reception
For
enhanced
FM
performance
the
MRGI-TUNE®
tuner
includes signal actuated
stereo control and Multipath noise reduction cir-
cuits.
Listening
to
the radio
1.
Press the [FNC] button and select the radio
mode.
2.
Press the [BND] button and select the radio
band. Each time the button is pressed, the
radio reception band changes
in
the follow-
ing order:
FM1
~
FM2
~
FM3
~AM
~
FM1
...
3.
Press the [
..........
]
or
[~]
button
to
tune
in
the
desired station.
Tuning
There are 3 types of tuning mode available, seek
tuning, manual tuning and preset tuning.
Seek tuning
1.
Press the [BND] button and select the desired
band (FM or AM).
*
If
"mYmJ"
is
lit
in
the display, press and hold
the
[BND]
button
for
1 second
or longer.
"cmI!J"
in
the
display goes off
and
seek tuning
is
now
available.
2.
Press the [
..........
]
or
[
....
] button
to
automati-
cally seek to the next station.
When the [
....
] button is pressed, the sta-
tion is sought
in
the direction of higher fre-
quencies; if the [
..........
] button is pressed, the
station
is
sought
in
the direction of lower fre-
quencies.
Manual tuning
There are 2 ways available: Quick tuning and step
tuning.
When you are
in
the step tuning mode, the fre-
quency changes one step at a time.
In
quick tun-
ing mode, you can quickly tune the desired fre-
quency.
1.
Press the [BND] button and select the desired
band (FM or AM).
*
If
"mYmJ"
is
not lit
in
the
display,
press
and
hold
the
[BND]
button
for
1
second
or
longer.
"mmJ)"
lights
in
the
display
and
manual tuning
is
now
available.
2.
Tune into a station.
To Next Page
Loading...
Need help?
General
