English
13 CMD6
5. OPERATIONS
Note:
• Be sure to read this chapter referring to the front diagrams of chapter “3. CONTROLS” on page 7.
Basic Operations
CAUTION
Be sure to lower the volume before powering
the source unit off. The unit remembers its
last volume setting.
Turning on/off the power
Press the [POWER] button to turn on or off the
power.
Note:
• System check
The first time this unit is turned on after the wire
connections are completed, it must be checked
what equipment is connected. When the power
is turned on, the “SYSTEM CHECK” appears in
the display, then the unit returns to the radio
mode.
Selecting a mode
1. Press the [DISC], [AUX/iPod], [AM/FM] or
[SAT] button to change the operation mode.
External equipment not connected with
CeNET is not displayed.
iPod/MTP can connect to this unit via USB
cable.
Adjusting the volume
1. Turning the [VOLUME] knob clockwise
increases the volume; turning it
counterclockwise decreases the volume.
The volume level is from 0 (minimum) to 33
(maximum).
Switching the display
Press the [DISPLAY] button to select the
desired display.
Audio Adjustment
You can adjust a audio effect or tone quality to
your preference.
WARNING
When the front panel is open, no sound is
produced, and source unit controls and
remote control unit operations are
disabled. Always shut the front panel after
changing the CD.
EXPOSING THE UNIT TO WATER WITH THE
FRONT PANEL OPEN WILL CAUSE
DAMAGE OR UNIT MALFUNCTION!
To change sound setting
1. Press the [AUDIO] button to switch to the
sound adjustment selection display.
2. Then press the [X] or [V] button to select
the audio adjustment mode.
Each time you press the [X] or [V] button,
the audio adjustment mode changes as
following order:
(“BBE MP”) ↔ “BASS” ↔ ”TREBLE” ↔
“BALANCE” ↔ “FADER” ↔ “
NO FADER”
In the case of display blinking “ENT”, you
can press the [ENTER] button to adjust the
setting value.
“BBE MP” can be selected only in the
CD/MP3/WMA/AAC and USB/iPod mode.
3. Turn the [UP/DOWN] konb to adjust the
selected audio mode.
4. After completing settings, press the
[RETURN] button to return to the previous
mode.
To Next Page
Loading...
Need help?
General
