Clarion DXZ945MP - Page 38

Operations Common to Each Mode
Setting the sensitivity of the
spectrum analyzer (S/A
SEHS)
This function allows you to adjust the sensitivity
(amount of deflection) of the spectrum analyzer.
For details on displaying the spectrum analyzer,
see "Switching the display" (cf. page 13) or
"Setting the screen saver" (cf. page 36).
• The factory default setting is "MID".
1. Press the [A] button to set to the adjust
mode.
2. Touch ~ f:J i' on the setting item display to
select "S/A SENS" under "DISPLAY".
3. Either touch ~ f:J i' on the right of the
display, or turn the [ROTARY] knob to adjust
the sensitivity.
* Select either LOW (small deflection
amount), MID or HIGH (large deflection
amount).
4. Press the [A] button to return to the original
mode.
Adjusting the display scroll
speed (SCROLL)
This feature allows you to slow down the scroll
speed when the scroll speed is too fast, making
it difficult to view the screen.
• The factory default setting is "SPEED 2".
1. Press the [A] button to set to the adjust
mode.
2. Touch ~ f:J i' on the setting item display to
select "SCROLL" under "DISPLAY".
ADJUST AlTODE
SCROLL » SPEED2
"'~AV "';X~t';.I6""tf'" ······"~{'''_mi'''''~''';,···
3. Either touch ~ f:J i' on the right of the
display, or turn the [ROTARY] knob to adjust
the sensitivity.
* This setting item can be adjusted within
the range SPEED 1 to SPEED 7.
Adjust this setting item while viewing how
the appearance of the display changes.
38 DXZ945MP
4. Press the [A] button to return to the original
mode.
Setting the auto-dimmer
(DIMMERIH)
This function allows you to dim the lighting of
the display matched to the illumination or the
brightness inside your car.
Select either "AUTO" (interlocked to the
brightness inside your car) or "ILLUMI"
(interlocked to the illumination inside your car)
as the auto-dimmer setting.
• When the auto-dimmer function is set to
"AUTO", the brightness of the display is
dimmed according to the brightness detected
by this sensor.
• Set the dimmer setting at DMR LEVEL.
• The factory default setting is "AUTO".
1. Press the [A] button to set to the adjust
mode.
2. Touch ~ f:J i' on the setting item display to
select "DIMMER IN" under "APPERNCE".
3. Either touch ~ f:J i' on the right of the
display, or turn the [ROTARY] knob to select
"AUTO" or "ILLUMI".
4. Press the [A] button to return to the original
mode.
Setting the dimmer level
(DMR LEVEL)
This function allows you to set how much the
displayed is to be dimmed.
• The factory default setting is "3".
1. Press the [A] button to set to the adjust
mode.
2. Touch ~ f:J i' on the setting item display to
select "DMR LEVEL" under "APPERNCE".
3. Either touch ~ f:J i' on the right of the
display, or turn the [ROTARY] knob to set
the dimmer level.