When the
P.EQ
effect is set to "OFF", the
PEQ
setting is not reflected on the music
source. This ends the P.EQ setting. Press
the [SOUND] button to return to the original
mode.
4. Touch
~I:I~
on the P.EQ menu No. to select
the
P.EQ
menu.
REQ§VI'ODE
SP
•
SEL»
FRONT
.....
RTN
5.1
ch
Surround
Decoder Operations
•
P.
EQ
adjustment
The settings that can be adjusted in the
PEQ
menu are as follows. The center frequency, gain
and Q curve can be stored to channel/band
combinations.
For example, center frequency "250Hz",
gain"
-8dB"
and Q curve "3" can be stored to band 1
on the front.
For details on the
PEQ
function, see
"P.
EQ
adjustment" (cf. page 21).
P.EQ
menus
SIGNAL
SP-SEL
BAND
...
FREQ
...
Q
...
GAIN
SIGNAL
.
5.
Touch
~
1:1
~
on the right on the display and
adjust the item as desired.
SIGNAL
(selects the adjustment signal):
Selects "P-NOIS"
or
"MUSIC"
• P-NOIS: set when pink noise is to be
used
• MUSIC: set to use music signals
SP-SEL
(selects the speakers whose
PEQ
value is to be adjusted):
Select one of "FRONT", "CENTER" or
"SURROUND".
• FRONT: front speaker
• CENTER: center speaker
• SURROUND: surround speaker
BAND
(selects the frequency band):
Select one of band 1 to 3
FREQ (selects the center frequency):
The adjustment range is from 20 Hz to
20 kHz.
Q (sets the Q curve):
Sets one of
1,3,5,7,
or
20 as the
sharpness of the Q curve.
GAIN
(adjusts the output level):
Adjusts the gain (output level) within the
range -12dB to +12dB.
(1
dB
steps, 25
points)
6.
Repeat steps 4 and 5 to adjust the desired
item.
7.
Press the [SOUND] button to return to the
original mode.
Changing
settings
When a
5.1
ch surround decoder is connected,
settings relating to music in the adjust mode are
changed.
Selecting setting items
The following describes the items whose
settings are changed.
For details of other items that are not changed,
see "Changing settings" (cf. page 34) at
"Operations Common
to
Each Mode".
1.
Press the [A] button.
The mode changes to the adjust mode.
2.
Touch
~
1:1
~
on the setting item display to
select the item to set.
* Touching
~
1:1
~
on the left of the display
switches main items 1 item at a time.
Touching
+1:1+
on the left of the display
switches sub-items continuously.
* Touching
~I:I~
on the center of the
display switches the sub-items 1 item at a
time. Touching
+1:1+
switches sub-items
continuously.
3.
When "THROUGH" is displayed at the right
of the display, touch THROUGH to switch to
the adjustment details display.
4. Either touch
~
1:1
~
on the right of the
display, or turn the [ROTARY] knob to set
the details.
•
To
return
to
the original mode
1. Press the [A] button again.
DXZ945MP
53
To Next Page
Loading...
