5.1
ch
Surround
Decoder Operations
• Setting items
Main
Item
Sub-item
SOUND
CENTER-SP
I SRD-SP I
SUB-WOOFER
• Setting the speaker
ON/OFF
(cf. page 54)
FRONT
HPF
I
CENTER
HPF
I
SRD
HPF
I
SUB-W
LPF
• Adjusting the speaker filter frequency (cf. Page 54)
SPGAIN
• Adjusting the speaker output level (cf. page 41)
DELAY
CENTER-SP
/ SRD-SP
• Adjusting the speaker delay time (cf. page 55)
DOLBY
D
D-RANGE
• Adjusting the dynamic range (cf. page 55)
PL
II
CONT
PANORAMA
/ DIMENSION /
CTR
WIDTH
• Setting the music mode in detail (cf. page 42)
Setting
speakers ON/OFF
(CENTER-SP/SRD-SP/SUB-
WOOFER)
Set the center speaker (CENTER-SP), surround
speaker (SRD-SP) and sub-woofer (SUB-
WOOFER)
ON/OFF.
Be sure to set this setting to "OFF" when there
is no center speaker, surround speaker
or
sub-
woofer.
•
The
factory default setting is "ON".
1.
Press the [A] button to set to the adjust
mode.
2. Touch
-t
I!:J
~
on the setting item display to
select "CENTER-SP" under "SOUND",
"SRD-SP" under "SOUND", and
"SUB-
WOOFER"
under "SOUND".
3. Either touch
-t
I!:J
~
on the right of the
display,
or
turn the [ROTARY] knob to select
"ON"
or
"OFF".
* In the case
of
"SUB-WOOFER", select
one of "ON+", "ON-"
or
"OFF".
Normally, select "ON+". However, when
"ON-" is set, an effect in the low range can
be strongly felt.
4. Press the [A] button to return
to
the original
mode.
54
DXZ945MP
Adjusting
the
filter
frequencies
of
speakers
(FRONT HPF/CENTER HPF/
SRD HPF/SUB-W LPF)
This function allows you to adjust the filter
frequency matched to the speakers you are
using.
• A speaker that was turned off in the section
"Setting speakers on
or
off
(CENTER-SP/
SRD-SP/SUB-WOOFER)" is not displayed.
•
The
factory default setting for
"FRONT
HPF"
or
"SRD HPF" is "THROUGH" (no filter), and
for "CENTER HPF"
or
"SUB-W
LPF" is
"120Hz".
•
Filter
adjustment
FRONT
HPF/CENTER
HPF/SRD
HPF
(high-pass
filter
adjustment)
This filter cuts bass sound from the front center
and surround speakers.
THROUGH
~
50Hz
~
80Hz
~
120Hz
Set
the filter matched to the speaker when
small-diameter speakers are used.
THROUGH
Set this when using speakers that can
generate bass.
THROUGH
cannot
be
set at
CENTER
HPF.
SUB-W
LPF
(sub-woofer
low-pass
filter
adjustment)
This filter cuts treble sound from the sub-woofer.
50Hz
~
80Hz
~
120Hz
Set the filter frequency to match the sub-woofer.
1. Press the [A] button to set to the adjust
mode.
To Next Page
Loading...
