Clarion NX302A

English
10
NX302A
Note:
*1ConnecttotheAUXaudioinputterminalandtheiPodvideoinputterminal.(Audioconnection
isrequiredonlywhen[Analog]isselectedfortheiPodoutputsignal.SeeOwner’sManual.)
*2In certainvehicles-Volkswagen/Opel/Vauxhall-it is necessarytoexchangethe accessory
<<Red>>andthemainpower<<Yellow>>connection,toavoidoverloadandlossofmemory.
*3Whenthe unitis installedina 1998or laterVolkswagen model,makesure tointerruptthe
<<Remote>>output.
 Disconnectthe<<blue/white>>wireandinsulatethefrontendsofthiscord.Abreakdownmay
occurifthecordisnotdisconnected,orfrontendsarenotinsulated.
Installation Guide
Connecting the parking brake cord
Connect the cord to parking brake lamp ground in the meter panel.
Note:
 • Connectingtheparkingbrakecordtolampgroundallowsyoutowatchvideoimageswhen
theparkingbrakeisengaged.
 • Whentheparkingbrakecordisnotconnected,themonitorwillnotdisplayvideoimages.
Parking brake lamp
cord to battery
Parking brake
Electro-tap
Parking brake signal cord
Parking brake cord (Grass-green)
Parking brake signal cord
Stopper
Parking brake cord (Grass-green)