To Next Page

To Previous Page

29NX405

English

English Quick start guide

Installation Notes

• Use only the supplied parts.

¾ÍÆËÈ½»ÁŲ½¼È¹ÊÌË¹Ê½ÍË½¼ƓÌÀ½ÑÅ¹Ñ»¹ÍË½¼¹Å¹¿½Ɩ

• Any holes made in the body of the vehicle should be sealed with a

silicon adhesive. If exhaust fumes or water penetrates into the vehicle,

this may cause an accident.

• Fasten the bolts securely when installing the unit. If the bolts are loose

an accident or malfunction could occur.

• Please note the position of pipes, tanks and electrical wirings before

installing the unit into the vehicle; failure in avoiding these may cause a

ŲÊ½ÇÊÅ¹Ä¾ÍÆ»ÌÁÇÆƖ

WARNING

• Loom all cables according to the instruction manual, so as not to hinder

operation.

• Wire the connecting cords/cables away from high temperature areas.

¾ÌÀ½»Ç¹ÌÁÆ¿ËÇ¾ÌÀ½»¹ºÄ½ËÅ½ÄÌƓÁÌ»ÇÍÄ¼»¹ÍË½¹Æ¹»»Á¼½ÆÌƯŲÊ½ºÑ¹

short circuit. Take care when wiring in the engine compartment.

• When wiring the connecting cables in a vehicle with an airbag system,

Æ½Î½Ê¾½½¼ÌÀ½»¹ºÄ½ËÌÀÊÇÍ¿À¹ÈÄ¹»½ÏÀ½Ê½ÁÌÅ¹Ñ¹Ű½»ÌÌÀ½ÇÈ½Ê¹ÌÁÇÆ

of the airbag. An airbag not operating correctly in an emergency may

cause increased injury.

WARNING

CAUTION

Connection Notes

• Verify wires with a digital multi-meter prior to making any connections.

Many new vehicles use multiplexed and/or low voltage circuits that can

be damaged if a test light or logic probe is used.

• Connect cables appropriately. If a wrong connection is made, this may

»¹ÍË½¹ŲÊ½ÇÊ¹»»Á¼½ÆÌƖ

• When passing cables through the body of the vehicle, use non-

conductive grommets. If the coatings of the cables are worn out by

ÊÍººÁÆ¿ƓÌÀÁËÅ¹Ñ»¹ÍË½¹Æ¹»»Á¼½ÆÌƓŲÊ½ÇÊ¹ËÀÇÊÌ»ÁÊ»ÍÁÌƖ

ƹ¾Ì½ÊÏÁÊÁÆ¿»¹ºÄ½ËƓŲÐÌÀ½ÅÏÁÌÀÁÆËÍÄ¹ÌÁÇÆÌ¹È½Ɩ

ƹ½ËÍÊ½ÌÇËÏÁÌ»ÀÇŰÌÀ½Î½ÀÁ»Ä½ÏÀ½Æ»ÇÆÆ½»ÌÁÆ¿ÇÊ¼ÁË»ÇÆÆ½»ÌÁÆ¿

cords to/from the unit, otherwise an electric shock, injury or accident

may occur.

CAUTION

Clarion NX405 Quick Start Guide & Installation Manual

Other manuals for Clarion NX405