4
XMA2
6.WIRED REMOTE CONTROL UNIT OPERATIONS
PWR / FUNC Button
1
Turning on and off the power
Press the PWR button 1 to turn the power on and press and hold it
for 1 second or longer to turn the power off.
Changing the operation mode
Each time the FUNC button 1 is pressed, the mode switches in the
following order:
Note:
• In tape mode, if no cassette tape is loaded in XMA2, “CASS”
flashes on the display and the radio mode is selected.
VOLUME Up (
w
) / Down (
z
) Buttons
2
Adjusting the volume
Press the VOLUME Up button 2 to increase the volume and press
the VOLUME Down button 2 to decrease the volume.
BAND Button
3
Note:
• In tape mode, the BAND Button on the remote controller is inop-
erative.
Changing the band (in the Radio mode)
Each time the BAND button 3 is pressed, the band switches in the
following order:
FM1 ➜ FM2 ➜ FM3 ➜ AM ➜ FM1.....
Play/Pause (
s
) / MUTE Button
4
Pause (in Tape mode)
Press the Play/Pause button 4. Playback pauses. To resume play-
back, press the Play/Pause button 4 again.
Mute (in Radio mode)
Press the MUTE button 4. The sound is muted immediately. To can-
cel, press the MUTE button 4 again.
■ XMA2 following operations are enabled by remote control with the Wired Remote Control Unit M101RC (sold separately).
WIRED REMOTE CONTROL UNIT
1 PWR (Power) Button
FUNC (Function) Button
2 VOLUME Up (w) / Down (z) Buttons
3 BAND Button [
]
4 Play/Pause (s) Button [
],
MUTE Button [
]
5 SEARCH Up(
) / Down ( ) Buttons
[
] : In Radio Mode
[
] : In Tape Mode
SEARCH Up ( ) / Down ( ) Buttons
5
Note:
• In tape mode, the SEARCH UP (
)/DOWN ( ) button on the re-
mote controller is inoperative.
Changing preset stations (in the Radio mode)
Each time the SEARCH Up/Down buttons 5 are pressed, the pre-
set station switches in the following order:
1 ➜ 2 ➜ 3 ➜ 4 ➜ 5 ➜ 6 ➜ 1.....
or
6 ➜ 5 ➜ 4 ➜ 3 ➜ 2 ➜ 1 ➜ 6.....
Be careful about adjusting the volume, as turning on the power
while the volume is raised to its maximum may harm your hear-
ing.
CAUTION
Radio Tape
To Next Page
Loading...
Need help?
General
