EasyManua.ls Logo

Clarke CFP-2000DS - User Manual

Clarke CFP-2000DS
40 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Form No. 70880A 3/08 revised 11/13
CFP-130, CFP-170, CFP-200
CFP-1700, CFP-1700DS
CFP-2000, CFP-2000DS
Polisher
This book has important information for the use and safe operation of this machine. Failure to read
this book prior to operating or attempting any service or maintenance procedure to your Clarke
American Sanders machine could result in injury to you or to other personnel; damage to the
machine or to other property could occur as well. You must have training in the operation of this
machine before using it. If your operator(s) cannot read this manual, have it explained fully before
attempting to operate this machine.
All directions given in this book are as seen from the operator’s position at the rear of the ma-
chine.
READ THIS BOOK
LEA ESTE MANUAL
LISEZ CE MANUEL
English (2 - 11)
Español (12 - 21)
Français (22 - 30)
ES
EN
FR
Operator’s Manual / Manual del operador / Manuel de l’utilisateur
MODELS:
01281A, 01280A, 01310A, 01320A, 01350A, 01431A,
01360A, 01390A, 01400A, 01401A, 01430A

Table of Contents

Questions and Answers

  • D
    Donald JohnsonSep 13, 2025
    Why is my Clarke CFP-2000DS wobbling during operation?
    • S
      Shawn FullerSep 13, 2025
      If your Clarke Sander machine wobbles during operation, it could be due to a defective pad where one side is denser than the other. It might also happen if the machine was left sitting on the brush or pad for too long, causing it to deform. Make sure the pad is properly seated into the pad holder bristles. A warped block on the brush or pad holder could also be the cause, requiring replacement.

Clarke CFP-2000DS Specifications

General IconGeneral
BrandClarke
ModelCFP-2000DS
CategorySander
LanguageEnglish

Related product manuals