Name: Clarke Clean Track S16
Brand: Clarke
Rating: 4 (1 reviews)

To Next Page

To Previous Page

A-12 Clean Track S16, L18 - 56091055 12/11

INSTRUCTIONS FOR USEA - ENGLISH

TROUBLESHOOTING

If the possible causes listed below are not the source of trouble, it is a symptom of something more serious. Contact your Clarke Service Center

immediately for service.

TRIPPING THE CIRCUIT BREAKER

The Circuit Breaker (18) is located on the Control Panel; it protects the electrical circuit and brush motor from damage due to overload conditions. If

the circuit breaker is tripped try to determine the cause.

Brush Circuit Breaker (5 Amp) Possible cause may be:

1 Debris wrapped around the brush drive (remove debris)

2 Brush setting too low (adjust to proper brush pressure setting)

3 Electrical short circuit (have your Clarke Service Center or qualiﬁ ed electrician check the machine)

Once the problem has been corrected, push the button in to reset the circuit breaker. If the button does not stay in, wait 5 minutes and try again. If

the circuit breaker trips repeatedly, call your Clarke Service Center for service.

POOR WATER PICKUP

Possible causes may be:

1 Recovery Tank Full (empty recovery tank)

2 Open recovery tank drain hose (secure drain hose cap or replace)

3 Recovery hose not connected at vacuum shoe (connect hose to vacuum shoe)

4 Recovery hose is kinked or damaged (replace the hose)

5 Recovery tank cover gasket leak (replace gasket)

6 Debris caught in vacuum shoe or recovery hose (clean vacuum shoe and recovery hose)

INADEQUATE SOLUTION FLOW

Possible causes may be:

1 Solution tank empty (ﬁ ll solution tank)