16
7.2 Annual certifi cation
Technical support relating to calibration certifi cation and/or operation of the
CLAVIS Belt Frequency Meter can be obtained from the manufacturer at:
techsupport@clavis.co.uk
phone: +44 191 262 7869
fax: +44 191 262 0091
The meter may be returned to the manufacturer for repair or recalibration at
any time.
A factory calibration certifi cate is included with each meter. Although the very
stable solid-state quartz crystal based system is not likely to go out of
calibration, some operating procedures call for annual gauge certifi cation. For
certifi cation/calibration purposes the meter may be returned to the
manufacturer at yearly intervals to have the meter recalibrated and certifi ed to
NAMAS/ UKAS (National Accreditation of Measurement and Sampling/United
Kingdom Accreditation Standards) standards.
The manufacturer must be contacted for detailed costs and shipping
procedures prior to any return. Contact information for Integrated Display
Systems Limited (IDS) is shown in Appendix 2.
There will be a charge for these services.
To Next Page