General safety tips
Safety fi rst – read and understand this manual before
operating the CLAVIS Belt Frequency Meter.
Never use your CLAVIS Belt Frequency Meter on moving belts.
Switch off and isolate any
belt drive system prior to
taking tension measurements
or attempting any other
installation work.
Do not drop the meter or
subject either the meter or
the sensor to other sharp
impact.
Do not put water, solvents
(including cleaning solutions)
or any other liquid on the
unit. Clean meter and
sensor with dry cotton cloth.
Do not pull on sensor cable.
Disconnect sensor from
meter by grasping the
connector grip only.
Do not leave the unit in
places that are humid, hot,
dust fi lled or in direct
sunlight.
Hint: When CLAVIS Belt
Frequency Meter is not used
for a while, remove batteries
and store unit in the case
provided.
Do not use your CLAVIS Belt
Frequency Meter in any
potentially explosive
environment.
Do not disassemble or
attempt to modify either the
meter or the sensing head.
To Next Page
Loading...
Need help?
General