ICS-2003 INTERCOM STATION
3-3
5. Test the integrity of the station’s audio path by temporarily setting a forced
listen to it.
6. Reset the station’s Matrix card in the Matrix frame.
7. Replace the station’s Matrix card in the Matrix frame.
8. Reset the station.
9. Replace the station.
• The operator cannot hear another station’s page or call signal tones.
1. Adjust the “Page Volume” control of the station using the configuration
program (refer to the Eclipse Configuration System Manual).
2. Check the station’s configuration to see if page override is enabled.
• Announce tones (eavesdropping indication, change tones, etc.) aren’t heard
at the station.
Check the configuration program to see if the monitoring tones and change
tones are enabled.
• No speaker audio from the external program feed.
1. Check the “Program” knob on the station’s front panel.
2. Check the program source.
3. Reset the station.
4. Replace the station.
• The headphone isn’t receiving audio from the external program feed.
1. If the external program feed is audible in the speaker, check the station’s
configuration program to ensure the program was not disabled for the second
earphone feed.
2. Replace the station.
• Accessory panels do not function.
1. Check the accessory panel’s connection on the station’s rear panel.
2. Ensure the external AC power transformers are correctly connected to the
accessory panels.
3. Check the configuration program to ensure the correct number of selectors are
configured.
BILL OF MATERIALS
MISCELLANEOUS
Device Description Part # Designator
CABLE 26 Pin 3 in Ribbon 730078
CABLE 34 Pin Ribbon 730181
CABLE 20 Pin Ribbon, 2mm connectors 730208
DISPLAY 60 x 480 Pixel EL Display 390056
SPEAKER 2 1/2 in. 8 OHM 3.5W 500103
CORD Power 610022
POWER SUPPLY+5, +12, & -12 V 760050
‘
To Next Page
Loading...
Need help?
General
