Clevo NL50MU - Removing the 4 G Module

Disassembly
2 - 16 Removing the 4G Module
2.Disassembly
Removing the 4G Module
1. Turn off the computer, turn it over to remove the battery (page 2 - 5).
2. The module will be visible at point on the mainboard (Figure 9a).
3. Carefully disconnect the cables & , and then remove the screw (Figure 9b)
4. The module (Figure 9c) will pop-up, and you can remove it from the computer.
5. Reverse the process to install a new module (do not forget to replace all the screws and bottom cover).
1
2
3
4
5
b.
c.
a.
2
3
5
1
5
4

5.4G Module
•1 Screw
Figure 10
4G Module Removal
a. Locate the WLAN.
b. Disconnect the cable
and remove the screw.
c. The WLAN module will
pop up and lift it out of
the computer.