Clevo P775TM - Removing and Installing the Processor

Disassembly
2 - 12 Removing and Installing the Processor
2.Disassembly
Removing and Installing the Processor
Processor Removal Procedure
1. Turn off the computer, remove the battery (page 2 - 5), and component bay cover (page 2 - 10).
2. Remove screws - from the heat sink unit in the order indicated on the label (i.e screw first through to
screw last Figure 8a)
.
3. Carefully (it may be hot) remove the heat sink unit (Figure 8b).
1
4
4
1
5
Figure 8
Processor
Removal
Procedure
a. Remove the screws
in the correct order.
b. Carefully remove
the heat sink unit.

5. Heat Sink Unit
•4 Screws
a.
b.
Note:
Loosen the screws in the reverse
order 4-3-2-1 as indicated.
2
1
4
3
5