To Next PageTo Next PageWhat does Swapped Thermistor Code 9 mean on my ClimateMaster Heat Pump?
If your ClimateMaster Heat Pump displays Swapped Thermistor Code 9, it means that LT1 and LT2 thermistors are swapped. To resolve this, reverse the position of the thermistors.
General| Category | Heat Pump |
|---|---|
| Cooling Capacity (BTU/h) | 26, 000 |
| Cooling Capacity (tons) | 2.17 |
| Refrigerant | R-410A |
| Phase | 1 |
| Compressor Type | Scroll |
| Model | TTV026 |
| Voltage | 208/230 |
Critical warnings and precautions for safe handling and operation.
Guidelines for condensate drainage and ductwork design.
Methods for sound reduction and condensate drainage for vertical units.
Critical warning regarding POE oil incompatibility with PVC/CPVC piping.
General info on CXM control, test modes, and retry.
General info on DXM control, test modes, and retry.
General safety features protecting the compressor and components.
Understanding fault codes and using diagnostic features.
Description of the control's start-up sequence.
How ClimaDry® operates and the reheat mode functionality.
Requirements for installation environment, power, and operational limits.
Specific conditions for initial unit commissioning and start-up.
Step-by-step guide for cleaning and flushing the piping system.
Specific procedure for flushing and purging ClimaDry® equipped units.
Comprehensive checklist for unit and system verification before operation.
Detailed step-by-step instructions for starting the unit.
Data on operating conditions and corrections for specific options.
Comprehensive table of faults, causes, and solutions.
Troubleshooting common faults like power issues, pressure, and cycling.
Diagnosing and resolving insufficient cooling or heating capacity.
Troubleshooting high head pressure and low suction conditions.
Addressing problems with discharge air temperature and humidity.
