Climecon CLEANMASTER Series - Changing the UV Lamp

clime con.fi
14
Lämmittäjänkatu 4 A, 00880 Helsinki, FINLAND · Tel. +358 (0)20 198 6600
© Climecon
 
upper position and then retightening them.
Install all grease separators back into the hood.

 
as the last.
Attach the UV lamp’s electrical
connector (quick connector) to
the hood’s ceiling and tighten it


the brackets and tighten the
hand knobs by turning them

Replace the UV lamp. Only
Climecon’s UV lamps can be
used in the CleanMaster® sys-

Climecon’s customer service.

Climecon’s customer service,
tel. +358 (0)20 1986 600.
10. Changing the UV lamp
4
8
12
9 10 11
5 6 7
2 3
ULTRAVIOLET RADIATION HAZARD
Please deliver your old UV
lamp to a collection point



and detach the UV lamp from the
brackets.
 
then the others.
Disconnect the UV lamp’s elec-
trical connector (quick connec-
tor) from the hood ceiling by


any maintenance actions!
Open the SlideSafe safety lock by loosening the hand knobs and



OFF
1
WEAR PROTECTIVE EYEWEAR DURING
INSTALLATION AND MAINTENANCE