Climecon CLEANMASTER Series - Starting the Cleanmaster Hood

To Next Page

To Previous Page

clime con.fi

Lämmittäjänkatu 4 A, 00880 Helsinki, FINLAND · Tel. +358 (0)20 198 6600

8. Starting the CleanMaster hood

-

tion to ensure its correct operation.

Hood connections in a Master/Slave assembly.

-



Datajamak 2x(2+1)x0.24. The ModBus data cable is connected to the

control device’s ModBus channel 2, to the points:

3: protection





1. Choose your language



2. Master/Slave

Climecon CleanMaster can be the device’s Master or

Slave device.





If the device in question is a separate hood or a group of

-

ter. Other settings do not need to be changed.

-



Master from the main controller and then the Slave





Slave devices during the initial start, and must be deter-

mined a Slave address from 1 to 9.









Other manuals for Climecon CLEANMASTER Series