6
Safety considerations
1. Safety considerations
1.1 Safety
Operate in compliance with the safety regulations in force.
To perform the operations use the following protective equipment:
– gloves, goggles, hard hat, ear protection, protective footwear, protective knee pads.
PPE available
All operations must be carried out by personnel trained on possible general, electrical and pressure
equipment risks.
Only qualified personnel may operate on the unit, as required by the regulations in force.
W
CAUTION DANGER
Before any intervention, read chapter “12. Maintenance” on page 161
1.2 Manual
The manual ensures proper installation, use and maintenance of the unit.
It is advisable to read this carefully so as to save time during the various operations.
Follow the instructions given to prevent damage to persons or property.
1.3 Situations of Risk
The unit is designed and constructed so as not to expose people to health and safety risks.
In the project phase, it is not possible to outline all causes of risk.
Installation, start-up, maintenance and repair all require specific knowledge and, if such are carried out by
inexperienced personnel, they may cause damage to property or people.
1.4 Intended use
The unit is intended only:
• for heating or cooling of water or water-glycol
• within the limits defined in the technical datasheet and in this manual
1.5 Installation
W
CAUTION
Outdoor installation
The location, the water, refrigeration and electrical systems must be determined by the system designer
according to local regulations in force.
Follow local safety regulations throughout all operations.
Verify that the power network characteristics are in compliance with data indicated on the serial number
label of the unit.
To Next Page
Loading...
Need help?
General