M0G940E8-00 04/07/08 pag 7
To reset the current alarm
ONLY AFTER THE CAUSE ELIMINATION !
TEST + ON/OFF contemporary for some
seconds
Modify the HOT SANITARY water temperature
Control parameter 117
Modify the water temp. in HEATING
Control parameter 33
Modify the water temp. in ECO HEATING
Control parameter
30
Modify the water temp. in COOLING
Control parameter ametro 32
Modify the water temp. in ECO cooling
Control parameter
29
Modify the water temp. in MAINTENANCE heating
Control parameter parametro 43
Modify the water temp. in MAINTENANCE cooling
Control parameter
42
Only by SERVICE
keypad
ALAR
M
S
TAT
U
S
SET
COMMON CAUSES OF SHUTDOWN
1. coils dirty - clogged by leaves - nearby obstacles - covered with snow
2. set point too low (in summer) or too high (in winter)
3. water in system is too hot (in summer, for example with machine left off over the weekend) or too cold (in winter)
4. water filter dirty
5. external permissions (remote ON-OFF etc. )
6. water cut-off valves closed
7. system not pressurized - air needs to be vented
8. system pump off
9. circulator pump not running (after seasonal shutdown)
10. unit exchanger dirty
11. fans blocked by snow
To Next Page
Loading...
Need help?
General