The operating sequence for
testing a subject with the
Intoxilyer
®
S-D2 is simple,
consisting of the following
basic steps. These should be understood and
followed to insure maximum efficiency of operation.
OPERATION CHECK LIST
1. Ready Check
2. Set
3. Attach Mouthpiece
4. Instruct the Subject
5. Take Sample
6. Observe Reading
7. Remove and Discard Mouthpiece
8. Reset and Wait
AMBIENT TEMPERATURE
The Intoxilyzer
®
S-D2 is designed primarily for use in the
32-104° degrees Fahrenheit (0-40° Celsius) temperature
range. Keeping the instrument within this range insures
minimum condensation of alcohol and water from the
7
SUBJECT
BREATH
TEST
INTOXILYZER
®
S-D2 Operator’s Manual
To Next Page
Loading...