CMi Intoxilyzer S-D2 User Manual

30
INTOXILYZER
®
S-D2 Operator’s Manual
a) Insure that the ‘SET’ button is in the
locked down position.
b) Place a forefinger over the sampling port
and apply continuous pressure to the
‘SET’ button. This should activate the
pressure switch and cause sampling
light ‘A’ to illuminate, followed by light
‘B’ approximately 2½ seconds later.
Check the S-D2’s
sampling lights
by 1) locking the
‘SET’ button,
and then 2)
placing a
forefinger over
the sampling
port and
applying
continuous
pressure to the
‘SET’ button.
The ‘A’ light
should activate,
followed about
2½ seconds later
by the ‘B’ light.
0
SECONDS
0
SECONDS
2½

CMi Intoxilyzer S-D2 Specifications

General

Brand	CMi
Model	Intoxilyzer S-D2
Category	Test Equipment
Language	English