If the PIR sensor battery level is becoming
exhausted, a ‘Bop’ will sound after the
arming acoustic signals (replace PIR
internal batteries. Use only 2 CR2032
batteries.).
System Disarming
To disarm the system, press the
disarming button 2 on the remote control.
Three high-pitched beeps will confirm
disarming and the dome light will turn ON
for approx 30 sec.
System arming without
internal sensors
The system can be armed without
enabling the wireless PIR sensor(s). To do
so, press button 3 on either remote control
to arm the system. One high-pitched beep
will be confirmed the system is armed with
the sensors excluded.
Tilt sensor exclusion
Arm the alarm as usual by pressing
button 1. After the usual two beeps wait
4 seconds and press button 3. Tilt sensor
exclusion is confirmed by one beep.
Tilt sensor adjustment
The TILT sensor sensitivity level is factory
set to trigger an alarm if the vehicle is tilted
at an angle of approx 1.5º with respect to
the x,y and z-axis.
Awning light
Arming/Disarming the alarm will
activate the awning light for 30 seconds.
Button 4 on the remote will also activate
the light for 5 minutes before automatically
turning o.
Typically awning light controls will only
be possible with factory installations.
Alarms
An alarm event will trigger the siren
for a maximum of 30 seconds. If the
alarm condition remains or the alarm
is not disarmed it will trigger another
cycle after a pause of 5 seconds.
Each alarm condition will trigger a
maximum of 8 cycles.
Alarm trigger memory
If there had been an activation in your
absence it will be signaled by 2 long beeps
on disarming, followed by a number of
high pitched ‘chirps’ to indicate the cause
of the last trigger.
Caravan equipment
150www.coachman.co.uk
Owners handbook 2022
Coachman Caravan Company Limited, Amsterdam Road, Sutton Fields Industrial Estate, Hull, HU7 0XF
NOTE:
Sensor exclusion is bound to a single
arming cycle. Sensors will automatically
be enabled the next time the alarm is
armed.
To Next Page
Loading...
Need help?
General
