Refrigerator operation
83
Owners handbook 2022
The refrigerator
is not
cooling
adequately.
The ventilation
around the cooling
unit is not sufficient.
Check that the ventilation
grille is not obstructed.
The evaporator is
iced up.
Check whether the
refrigerator door closes
properly. Make sure
that the refrigerator seal
fits correctly and is not
damaged. Defrost the
refrigerator.
The temperature is
set too high.
Set a lower temperature.
The ambient
temperature is too
high.
Remove the ventilation
grille for a while so that
warm air can escape
quicker.
Too much food
was placed in the
refrigerator at the
same time.
Remove some of the
food.
Too much warm food
was placed in the
refrigerator at the
same time.
Remove the warm food
and leave it to cool down
before putting it in again.
The refrigerator has
not been operating
for very long.
Check the temperature
again after four or five
hours.
Fault messages and signal tones
All faults are indicated by a warning symbol, a fault ID and a
beep. The beeping lasts for 2 minutes and is repeated every 30
minutes until the error has been rectified.
If multiple faults occur, the display shows the most recent fault.
The underlying faults are displayed after the last fault has been
confirmed.
RM10.5T, RMS10.5T, RMS10.5XT: Faults are indicated by a
fault code with a warning symbol (
) in the middle of the TFT
display.
RM10.5S, RMS10.5S, RMS10.5XS: In the event of a fault, the
LED warning symbol (
) in the display lights up continuously
and the LEDs flash according to the fault.
To Next Page
Loading...
