What to do if COBHAM Marine Equipment system cannot be switched on?
If your COBHAM Marine Equipment system isn't turning on, and the Message Terminal uses a remote on/off switch, try using that instead of the power button. Also, verify that all power cables connecting the ship's power source to the Message Terminal are properly connected and that the power source is active.
What to do if COBHAM Marine Equipment Message Terminal shows “out of paper” although there is paper in the printer?
If your COBHAM Marine Equipment's Message Terminal displays an 'out of paper' message even when the printer has paper, make sure the paper is positioned correctly on the left side of the printer.
What to do if there is no connection between Message Terminal and MF/HF radio on COBHAM Marine Equipment?
If there is no connection between the Message Terminal and the MF/HF radio of your COBHAM Marine Equipment, check these steps: 1. Ensure the CAN cables are correctly connected to both the Message Terminal and the MF/HF radio, and that they are undamaged. 2. Verify that the MF/HF radio is powered on and ready. 3. As a general step, switch off both the MF/HF radio and the Message Terminal, then switch them back on.
Why is there no battery information in the COBHAM Marine Equipment Message Terminal?
If your COBHAM Marine Equipment Message Terminal doesn't show battery information, first check the Ethernet connection from the power supply by examining the Link activity indicator at the Ethernet switch connection points. Ensure the Ethernet cables are correctly connected and undamaged. Note that battery and power information is displayed only if the power supply is a SAILOR 6081.
How to fix no connection between Message Terminal and printer in COBHAM Marine Equipment?
If there is no connection between the Message Terminal and the printer of your COBHAM Marine Equipment, check that the USB cable is correctly connected and is not damaged.
Overview of the SAILOR MF/HF System 6000B Radiotelex and its communication capabilities.
Details on the Radiotelex program running on the SAILOR 6018 Message Terminal.
Procedure for sending a DSC Distress alert in immediate danger situations.
Steps to configure and initiate a telex call, including transmission modes.
Guide to establishing and conducting a telex call session.
How to access and configure various system parameters and preferences.
Steps to create a diagnostic report for troubleshooting.
Table of common problems, their causes, and remedies.
Explains system status messages, alerts, and popup windows.
General| Channel spacing | 25 kHz |
|---|---|
| Transmitter output power | 25 W / 1 W |
| DSC | Yes |
| Display | LCD |
| Operating temperature | -15°C to +55°C |
| Storage Temperature | -25°C to +70°C |
| Humidity | up to 95% non-condensing |
To Next Page
