Chapter 2: Operation
34 Scan frequencies
To add a frequency to the list
1. From the SCAN LIST page, select the field where you want to add a
frequency. For example, select Manual frequencies to add
frequencies manually.
The manual frequencies are listed.
2. Select N
ew at the bottom.
3. Type in the Receive and Transmit frequencies or select from the list of
Co
ast stations.
4. Select O
K.
5. To stop editing the scan list, select O
K again.
You must always enter a transmit frequency, even if it is not
used (e.g. for NAVTEX, which is receive only). The transmit
frequency must be within a valid maritime frequency band
specified by ITU. The receive frequency must be between 490
and 27500 kHz.
To Next Page
Loading...
